Assessment
Solution · Energy

Drone inspection of solar panels and wind turbines

We inspect your solar panels and wind turbines from the air, with drones and other sensors, to detect faults in time and keep them performing as they should.

Book an assessment
How it works
Industrial roof with solar panels seen from a drone
Solar panelHot spotCheck the module
What we inspect
Solar panels and wind turbines
With what
Drones and other sensors
What you get
The faults detected and where they are
What for
Performance and energy efficiency
What it is

Drone inspection analyses solar panels and wind turbines from the air. With the drone and other sensors we carry out a thermodynamic analysis of the installation: we measure its heat to detect faults before they cost it performance. It is for anyone with solar panels or wind turbines who wants to inspect them remotely.

These are phases 1 and 2 of our industrial data analytics method

How it works

From the flight to what needs checking, in four steps

  1. Step 1

    We fly over the installation

    The drone covers the solar panels or the wind turbine.

  2. Step 2

    We measure its heat

    With the drone and other sensors we carry out the thermodynamic analysis of each panel.

  3. Step 3

    We locate the faults

    Hot spots show where there may be a failing module.

  4. Step 4

    We tell you what to check

    With your team, we look at what should be checked to recover efficiency.

What we measure

What heat tells you about your installation

In the assessment we decide what to inspect and with which sensors.

Panel temperature

Hot spots give away the modules that are failing.

°C

Wind turbine condition

Faults that cost them performance.

What you get

Where the fault is, and what to check

We don’t just leave you a recorded flight: we tell you what it found.

Early detection

Which module is failing

We point out the faults detected and where they are, before output drops.

Remotely

The condition of your installation

You follow the condition of your panels and wind turbines without travelling to each one.

Where it applies

Drone inspection in energy installations

Sectors

Energy

Solar panels and wind turbines that have to perform as they should.

See the sector
Related solution
Solution

Energy monitoring

Every kWh in your plant or building, measured and explained.

See the product sheet
Frequently asked questions

Drone inspection, in a nutshell

If your question isn’t here, ask us during the assessment.

Which installations do you inspect?

Solar panels and wind turbines.

What does the inspection detect?

Faults that cost performance. With the thermodynamic analysis we locate the hot spots on the panels.

Do you only use drones?

No. We use drones and other sensors, depending on what needs inspecting.

What is the point if the installation is already producing?

To detect faults in time and improve its energy efficiency, so it performs well for longer.

Are your panels performing as they should?

Tell us about your installation in two lines. In the assessment we tell you what to inspect, with what, and what to expect.

Or call us on +34 979 724 985

Basic data protection information. Controller: Alsis IoT Industrial S.L. Purpose: to handle your request and, if you tick the box, to send you commercial communications. Legal basis: your consent. Recipients: data is not disclosed to third parties unless required by law. Rights: access, rectification, erasure and other rights, as explained in the privacy policy.

Fields marked * are required
© 2026 Alsis IoT Industrial S.L.